No need to dismantle the alternator (connection similar to that of a relay) Three-phase charging cycle (IUoU) with temperature compensation (temperature probe supplied) 7 LED with 4 dual mode plus 3 for indications of charging status and battery selection.Fast (2 to 5 times faster) and complete recharge of the batteries from the alternator.Output reversed polarity protection with thermal fuse.When battery temperature is over 60✬, the charger will shut down.Īt high operating temperature charger will gradually decreases the output power to protect the electronic components from further thermal stress and at the same time keeps a safe and continuous charging until the high limiting temperature 60✬ is reached, charger will then shut down and self restart when charger cools down. When connected to the supplied battery temperature sensor, the charging voltages changes with the battery temperature such that charging voltage decreases with rise of temperature and increases with drop of battery temperature. Temperature compensated charging & Battery Protection.Half Power Mode for batteries with low Ah ( less than 100Ah).8 hour sleep Mode or the Half Power Mode with half power presents noiseless operation.Front Exhaust design with temperature control variable speed fan for cool and quite operation.Battery temperature sensor is supplied as standard accessory.The charger is housed in a robust anodized Aluminum body completed with Poly carbonate end caps. The charger can be used to power up dc load when not connected to battery. There is no Float and no automatic refreshing cycle charge for LFP.Ī load can be connected to the battery during charging as long as the load is not larger than the rated output of the charger. There are only two active charging stages namely Bulk and Absorption, at the end of Absorption is the inactive (no charging current) Standby Stage. There is a special charge algorithm and treatment for Lithium Ion Phosphate (LFP) batteries to ensure safe and optimal charging adaptive to the special chemistry of the battery which is quite different to Lead Acid battery. There is a manual equalization mode for lead acid batteries either in plate or cylindrical cells subject to the recommendation of manufacturer. This is to keep the electrolyte and the cells of the lead acid battery in good working condition. This Standby stage also helps to reduce grid corrosion.Ĭharger will automatically give a refreshing cycle charge (fast bulk & absorption, float) at 7 days interval of inactivity. The charger will enter into an energy conversation (Standby) stage with lower Float Voltage after long period of inactivity of 8 hours or more has been detected. When the battery voltage rises to a preset value then constant voltage charge occurs with decreasing current which leads float charging with lower constant voltage to keep the battery ready and light refill for any self-discharge or light load. Both soft-start and bulk charges are in constant current without exerting high voltage to the battery. When battery is deeply depleted (battery voltage is less than 24V) soft-start charging is activated with half rated charging current until battery voltage rises to 24.8V then normal bulk charge with full current will kick in. Soft-Start/ Bulk/ Absorption/ Float/ Standby There are 5 Stage Charging for LEAD ACID based batteries namely: Battery with and without load can be connected to the charger all the time and the charger will keep on monitoring the battery. ![]() This pro charger is designed for applications that demand adaptive charging for Lead Acid based and LiFePO 4 (LFP) batteries.
0 Comments
Leave a Reply. |